The download files will be provided in *.rar compression file archives. To unpack the file contents, either use WinRar (winrar.de) for windows, or The Unarchiver App (Apple App Store) for Mac OS. Both applications are free of charge.
1/35 scale printable parts, snap fit assembly, no glue required. Figure height: approx. 2 inch / 5 cm
The parts come in pre-supported Chitubox files (SLA and DLP) and non pre-supported STL file format (for all other printers, FDM).
We highly recommend to choose SLA or DLP printers!
FDM prints usually do not show the very fine detail, unless you scale up the parts
Wash the parts in IPA (70%-99%) for 20 minutes. UV post cure the parts for 20 minutes.
Assemble the parts after curing, to avoid dusting/powdering of the resin surface!
If you prefer a tight fit and don't want to exchange parts after assembly, you can use a 5.0 seconds layer exposure time. If you prefer less tight fit for ongoing parts exchange, you can use a 4.0 seconds layer exposure time.
You can also mix any other of your prefered resins with Siraya Tech Tenacious (ideally 80/20 ratio).
The joint fits are quite tight in the beginning, so make sure to wiggle the parts together slowly and carefully to avoid breaking parts. Should you still struggle to assemble the snap fit joints, place the parts in hot water for 30 seconds to soften them a bit, then assemble. Some printed resin tends to shrink over time (the process can go on several weeks after print) until it has fully settled it's properties. If the joints come loose, use small portions of modelling clay, like super sculpey to fill in the gaps.